This article give you the steps to configure your iPhone:
- Steps to setup an iPhone with iOS 14 or more
- Steps to setup an iPhone under iOS 11, iOS 12 or iOS 13
- Steps to setup an iPhone under iOS 10
Steps to setup an iPhone with iOS 14 or more
Starting with iOS 14, you can take advantage of its compatibility with the DNS over HTTPS (also known as DoH) protocol to access our SmartDNS Servers through an encrypted SSL Tunnel. This way, your Internet Provider will not be able to capture or filter your DNS communications.
To configure your iPhone with our Secure DNS follow these steps:
- Download the configuration profile file available here: https://liberador.net/doh.mobileconfig
- Click on Allow to start the download
- Go to Settings > General > Profiles
- Under Downloaded Profiles, select Liberador Encrypted DNS over HTTPS
- In the Install Profile screen, click on Install
- Enter the passcode if asked
- In the warning message, click Install
- In the Install Profile message, click Install
- Click Done
- Restart your iPhone
Steps to setup an iPhone under iOS 11, iOS 12 or iOS 13:
- Click on Settings and then click on Wi-Fi.
- Click on the network you are connected.
- Scroll down to DNS and click on Configure DNS.
- Select Manual and remove all the existing DNS Servers.
- Then click on Add Server and enter address 45.63.105.236 and click again on Add Server and enter address 51.91.192.251
- Click on Save.
- Restart your iPhone.
Steps to setup an iPhone under iOS 10:
- Click on Settings and then click on Wi-Fi.
- Click on the network you are connected.
- Click on the DNS Field and delete current address.
- Enter these DNS server adresses: 45.63.105.236, 51.91.192.251
- Restart your iPhone
Important
First step of troubleshooting should always be to restart device(s) and router. Then check your account status in your account. You should always see 3 green check marks if the device you are using to visit the account home is set up correctly.